Pairing
Getting started
Make sure your Bluetooth is activated on your phone
Plug in or install the light
Open the app
Your light is on - let’s go
Lighting configuration
1 – Press Add New Device or “+” to enter the configuration interface
2 – Press Lighting (Bluetooth)
3 – Make sure the light has already been flashing, press Next
Notice: Please allow access to Bluetooth on your phone
4 – Start searching device
5 – Press Add once the device appears
6 – Wait for the configuration to finish and then press Next
7 – Press Done when there is a new device showing on the list
Can’t find your device?
How to put your light into connection mode
Regular Light
- Power OFF your lights
- Power cycle them 5 times
ON/OFF-ON/OFF-ON/OFF-ON/OFF-ON :
every time stay off for more than 2s) - Your light should be flashing in cool white
Wire Switch Light
- Power OFF your lights
- Power cycle them 3 times
ON/OFF-ON/OFF-ON/OFF-ON/OFF-ON :
every time stay off for more than 2s) - Your light should be flashing in cool white
Battery Light
- Power ON your light
- Press ON/OFF button for 10s
- Your light should be flashing in cool white
Strip Light
- Power ON your light
- Press ON/OFF button for 10s
- Your light should be flashing in cool white
2 – Check that Bluetooth is enabled on your mobile device
and the LUTEC Connect app has permission to use Bluetooth.
3 – Ensure you enable location services for your mobile device
and the LUTEC Connect app has permission to use location services:
On IOS :
On Android :
